Description

Conventional Base Mount Sounder

The C-9402 Conventional Base Mount Sounder (the sounder) is an audible signal appliance in field, used together with I-9308 module. When there is a fire, the sounder gives alarming sound to warn people.

Recommended Cabling
1.0mm2 or above fire cable, subject to local codes.

The Conventional Base Mount Sounder has the following features:-

• Operating Voltage: 24VDC
• Alarm Current: ≤15mA
• Sound Level ≥85dB
• Ingress Protection: IP31
• Temperature: -10℃～+50℃
• Humidity: ≤95%, non condensing
• Material: ABS
• Color of Enclosure: White
• Dimension Diameter: 120mm x 38.8mm
• Weight About 130g

Installation
Warning: Before installing the sounder, disconnect the power from loop and verify that all the bases are securely installed and that the cabling is correct on each base.
1 Before installation, first check the enclosure without scrapes and distortion, the labels should be complete.

Application
The sounder can be used as a base to install intelligent heat or smoke detectors to combine detection and alarm. It can also be used as a sounder. The audible control part of the sounder has two wires. Used as the sounder, it needs separate wiring to connect with detectors.
 The sounder can be directly connected to I-9308 module, which occupies two consecutive address points. When there is fire alarm message, it activates low address to give pre-alarm sound, activates high address to give fire alarm sound.