Description

I/O Interface Single Way Input & Output Module I-9300

The I-9300 Addressable Input Module is designed to receive normally open or normally closed switch signal from fire devices with coincidence functions, and transmits these messages to fire alarm control panel (FACP) with coincidence detection function. When a device of this kind is activated, the module can send the output signal through signal loop to FACP to alarm or activate relative devices.

Connection and Cabling
Connecting with volt-free normally open contact (closed to activate and report alarm) of the device, it can be set to normally closed or normally open cable monitor.

The I/O Interface Single Way Input & Output Module I-9300 has the following features:-

• Average Current ≤1mA
• Indicator Red, flashes when polling.
• Ingress Protection: IP30
• Temperature: 0℃～+49℃
• Humidity ≤93%, non condensing
• Material: ABS
• Dimension: 120mm×80mm×39mm
• Weight About 181g (with base)

Recommended Cabling
1.0mm2 or above fire cable for each terminal. Subject to local codes.

The I/O Interface Single Way Input & Output Module I-9300 has the following specifications:-

 Working mode can be set to normally open, normally closed and normally open cable monitor through programmer.
 Electronically addressed. The address can be modified in field.
 The built-in microprocessor processes messages intelligently.
 Insulation technology for input signal, good anti-interference ability.
 Plug-in structure.
 Standard: EN 54-18:2005.

Installation
The module is simply plugged onto the base after corresponding terminals are connected. If the cable conduit is inside the wall, the base is installed onto the Back Box. If the cable conduit is on the surface of the wall, B-9310 Back Box is available.
Note the upward arrow for mounting direction

Application
The module is designed to connect with active devices in field such as water flow switch, pressure switch, position switch, signal valve and devices able to transmit back switch signals. Address and working mode can be set through GST programmer, refer to P-9910B Hand Held Programmer Installation and Operation Manual for specific operation. Working mode is defaulted to normally open (4), while it can be modified to normally closed (7) or normally open cable monitor.