Description

New Addressable Combined Sounder And Strobe

The I-9406 addressable Combined Sounder And Strobe is installed in field to warn people for evacuation with audible and visual alarm in case of a confirmed fire. The flashing beacon base can communicate with fire alarm control panel (FACP) through a built-in microprocessor.

On receiving a start command from the FACP, the microprocessor will control the buzzer to generate the pre-set fire alarm sound and light the bright LED.

The New Addressable Combined Sounder And Strobe has the following features:-

• Make: GST
• Model code: I-9406
• Siren Type: Electronic
• Use: Perimeter
• Type: LED

Features of New Addressable Combined Sounder And Strobe
 With “sandwich” structure, it is easy to be installed between DB-01 base and a detector.
 Three working modes settable (Mode I, II, III, and the latter two available with pre-alarm state).
 16 tones of sound and bright flashing light.
 Electronically addressed. The address and tones can be modified in field.
 Tone 14 and 16 are certified by EN54-3

Application

The New Addressable Combined Sounder And Strobe can be used as the base of intelligent heat and smoke detectors to combine detection and alarm in a single device. It can be connected to the loop of FACP without additional power supply.

Working Mode Setup and Tone Selection
The flashing beacon base has three working modes. The factory default is tone 14, mode I. The flashing beacon base has 16 tones, the setup of which also decides the setup of working modes.
 If the flashing beacon base is set with one of the tones from No. 1 to 16, it works in Mode I.
 If it is set with one of the tones from No. 17 to 32, it works in Mode II.
 If it is set with one of the tones from No. 33 to 48, it works in Mode III.