COUNTRYWIDE DELIVERY...
-11%
Dual Interface Double Input Output Module
Original price was: KSh 11,500.00.KSh 10,231.00Current price is: KSh 10,231.00.
| Humidity |
90%
|
| Display Type |
Digital
|
| Model Name/Number |
I-9303
|
| Dimensions Mm |
120X80X39 mm
|
| Operating Current |
1 mA
|
| Operating Temperature |
0 to 49 degree C
|
| Operating Voltage |
240 V
|
| Weight |
194 g
|
| Material |
ABS
|
- Description
- Reviews (0)
Description
Dual Interface Double Input Output Module
The Intelligent addressable input/output module. With dual volt free relay with N/O and N/C change over contacts that can be driven via the fire alarm loop. Commonly used for overriding equipment such as AHU’s, smoke extracts, lift returns, auto dialer, BMS, etc. The input can be linked through a volt free contact switch output of ancillary equipment reporting to the fire alarm controller. According to the pre-inputted cause and effects interface programming, the alarm controller sends out a start command to the equipment required to start.
The Dual Interface Double Input Output Module has these specifications:-
Application: Input or Output (Single circuit)
• Input: programmable NO/NC
• Output control mode: NO/NC passive contacts; 24Vdc
• Output Capacity: Passive: 5A/24Vdc, Active: 24Vdc/ 1A
• Operating Current: Loop: Standby=1mA; Alarm=2mA, PSU: Standby=3mA; Alarm=15mA
• Operating Voltage: Loop: 24V (16V~28V), PSU: 24VDC (20VDC~28VDC)
• Operating temp:0°C to +49°C
• Relative humidity: 93%
• Protection rating: IP 30
• Addressing: 1 to 242 using P-9910B
• Application: Indoor use
• Visual Indicator: LED, steady red when in alarm state, 3sec interval blinking at normal state; Yellow (fault)
• Material and color: ABS, off-white
• Wiring: 6 wires: 2 wire for loop ( non-polarized) ; 2 wire for power cable( non-polarized) ; 2 wire for output/input
• Dimensions: 120mmx80mmx39mm
After receiving the command, the module activates its relay to change state. Once the equipment under control has operated a confirmation signal can be sent back to the fire alarm controller. Electronic addressing can be done through Handheld Programming tool (P-9910B), purchased separately.
The Dual Interface Double Input Output Module has the following features :-
Intelligent dual I/O with 24Vdc/5A relay output contacts
• Input can be configured as NO/NC or self confirmation
output
• LED status indicator
• Electronically addressable
• Characteristics one input or output
• First fix base for easy and safe installation.
The module should be installed in compliance with all local codes, BS5389, and EN45. It is installed onto a standard one gang electrical box with a mounting hole that have 6.5cm spacing.
| GST I-9303 addressable dual I/O module, with a microprocessor, can communicate with FACP, monitor power supply, judge the logic state of input signal, control output and state indicators. The module occupies two addresses, and each address can independently receive start command from FACP, close the relative relay and light the indicator. Each address corresponds to one input. After receiving feedback signal from a device, the module transmits feedback signal to FACP in the way of corresponding address. It can be used as two single input/output modules. |
Reviews
There are no reviews yet.